Thermal Instrument Company introduces flare gas flow measurement system

Gas flaring. Torch against the sky.
Source: DollarPhotoClub

Thermal Instrument Company, a 55-year-old designer and manufacturer of industrial precision-made thermal mass flow meters, has recently launched its flare gas flow measurement system for use in the upstream oil & gas exploration areas.

This flare gas flow metering package brings oil and gas exploration companies into mandatory monitoring compliance on flare gas systems as governed by state and federal environmental regulatory agencies. This Greenhouse Gas (GHG) Reporting Rule, 40 CFR Part 98, Subpart W is pertinent to reporting requirements and data collection for the upstream oil & gas exploration industry.

Thermal Instrument Company Flare Gas Flow
Model 9500 Flare Gas Flow System from Thermal Instrument Company (PRNewsFoto/Thermal Instrument Company)

In March 2014, the U.S. EPA published some proposed revisions to this 40 CFR Part 98, Subpart W to include general applicability, revised calculation methods and reporting requirements for specified emission sources within the source category, and some other changes to monitoring standards. Additionally, a Subpart OOOO (Quad O) has become another EPA standard for upstream & midstream gas exploration emissions compliance that must be met.

There are a small handful of oil & gas exploration companies taking the proactive approach early on to engineer the flow monitoring instrumentation onto the well pad site for monitoring the mass flow exiting the flare. At this point, the EPA has defined January 1, 2015 as a technically feasible date when the proposed revisions will be effective for this mandated monitoring and recording of flow exiting the flares at oil & gas exploration well sites.

In cooperation with a major gas exploration company in the Texas area of the Eagle Ford Shale formation, Thermal Instrument Company enhanced and completed their total flow monitoring system. Even with changes in gas composition, the flow monitoring system from Thermal Instrument Company was very repeatable and accurate and the customer was amazed at the less than five minute start-up time. The system can vary from just the flow measurement design to the whole package including solar panels, totalization module, and battery management hardware.

Article continues below this message

Have your opinion heard with Shale Gas International

We accept interesting, well-written opinion and analysis articles of up to 1,500 words, that offer unique insights into the shale industry. The articles cannot be overtly promotional in nature and need to fit into at least one of our content categories.

If accepted, the article must be exclusive to Shale Gas International website and cannot appear on any other websites, publications, etc. Each article may contain up to three links to external websites relevant to the content discussed in the piece.

If you would like to contribute to Shale Gas International website, please contact us at: editor[at]mw-ep.com